混凝土课后答案（Concrete answer）.docVIP

混凝土课后答案（Concrete answer） The first chapter is introduction Thinking question 1.1, the characteristics of reinforced concrete beam failure are: tensile steel yield, compression zone concrete is crushed, deformation before failure is larger, there are obvious signs, belongs to ductile failure type. In the reinforced concrete structure, the concrete compressive ability and tensile ability is very weak, the characteristics of the strong tensile capacity of reinforced concrete beams, with the main shaft and the pressure above the compression zone, reinforced mainly bear the neutral axis in the tension zone of tension, even if the tension zone of the concrete beam can continue to bear the load quite large, until the tensile steel yield strength, load and slightly increase the compression zone concrete crush, beam failure. Due to the good adhesion between the reinforced concrete and hardened concrete, and the temperature of steel and concrete two material expansion coefficient is very close, when the temperature changes, the bond can be generated between the big thermal stress and the failure of the two, so as to ensure the cooperative work of steel and concrete. The advantages of 1.2 reinforced concrete structure are: 1) the economy is good, the material properties are used reasonably; 2) mouldadibility; 3) durability and good fire resistance, low maintenance cost; 4) good integrity, and through appropriate reinforcement, can obtain better ductility stiffness; 5) 6, large damping materials). Disadvantages are as follows: 1) from the major (2); crack resistance is poor; 3) bearing capacity is limited; 4) complex construction; 5) reinforcement difficulties. 1.3, the main content of this course is divided into two parts: the design principle of concrete structure and the design of concrete structure. The basic theory of concrete structure stress performance, cross section design calculation method and construction of the former is mainly about the basic components of all kin