电路设计经验总结（Circuit design experience）.docVIP

电路设计经验总结（Circuit design experience） The output of the triode buffer is added to the pre operational amplifier as feedback, so that the stability can be further improved A unit with a high impedance input can not be directly coupled with a capacitor (input no current, capacitor cannot charge discharge, circuit does not work), and then a resistor to ground. The integral circuit must be connected in parallel with a large resistor to suppress the direct current, otherwise the output is saturated. The single power COMS operational amplifier configured the operational amplifier as an inverting amplifier and minimized the closed-loop gain to avoid cross distortion. If the positive phase, you can choose an amplifier with a rechargeable pump The input voltage is used as the reference voltage of DAC, and programmable attenuation can be realized. Amplitude control can be realized in the waveform output. 150K triangle wave and audio signals can be obtained by BTL through the zero comparator, the PWM control signal (class D power amplifier) The electret signal advanced automatic gain amplifier can also be used to implement differential input of speech signals using dual microphones to eliminate background noise. The speech output of digital processing needs high frequency compensation correction, and can be realized simply by a low pass filter. The LM1894 can realize dynamic noise reduction, while paying attention to simple voice data compression, incremental modulation, differential pulse code modulation method, silence compression algorithm. Speech recognition relies on the number and frequency of zero speech sounds. For systems with large inertia, automatic control requires mathematical modeling, such as water temperature control (PID algorithm). Two tandem push-pull emitter follower is good stuff ah, combined with the operational amplifier can greatly improve the output power, but the end of a string of input impedance of 100 ohms, to prevent the oscillation circuit if the c