.内衣专业知识.docVIP

1.Stitching / Thread??线步/线( r p6 c p; m: R??Q; j) s$ U b5 p% z7 f% b1.1 Bad stitching at front pocket opening./开前袋线步差。0 c$ O$ G6 d y S. k1.2??Garment were less than our standard of 9.S.P.I. / 成品的线步比要求每寸9针标准低。: I( ?6 U0 U# F( t1.3??Uneven stitching of density on standard on bottom edge stitching / 裤脚线步密度不均匀。) v, ]. ^$ f# p0 @ |1.4??Loose thread ends not removed from garment / 成品没有剪线头。7 F, ], }$ {4 d1 _* @+ ?1.5??Thread ends not trimmed and should be flushed with the garment./成品线头未剪，应该剪干净。! p b/ d2 a8 i# P1.6??Skipped stitches/跳线，??Double stitches/重线,??Broken stitches/断线,??Run off /?线落坑/ a/ P) @ N1 u9 c: q1.7??Loose thread/松线，Thread distorted /线扭曲,) R3 o1 ?5 k a1.8??Needle holes or needle burns /针孔或消针 o) b4 m( ]5 O: e1.9??Part of garment caught in unrelated operation/成衣部分由无关工序所组合。 ^, G) \/ O4 M+ n* k1.10 Improper sewing-stitching density( too loose, too tight)/线步密度不适当（太松，太紧）# ~( y4 S$ k1 n2 G9 Y; Q3 ?) P3 q1.11 S.P.I. more/less than specified / 每针线步比规定多或少。. U* O: R+ B* z) \; l5 ~1.12 End of stitching not back-stitching ,tied in (securely caught in ) other seam/线步未翻针车死其它骨口。- t5 b) U3 ^0 |1.13 Excessive sewing thread shrinkage compare to fabric /相比布料，线的缩水度太厉害。+ |7 z7 g4 i; I* h1.14 Blind stitching were shown on top fabric/暗线外露。) B P( c: }/ O Q! F/ q1.15 Front pleat stitching uneven width/length 前折线步宽度或长度不均。0 ^ ~) Q# ~2 G, l1.16 Poor stitching on hemmed bottom /裤脚环口线步差。! h; w+ { S b q8 V0 c, x1.17 Join stitching not in the same line/ 线步翻针位没有在同一?位。 E1 w6 V; k L: \( Z1.18 Upper stitching tension are tighter than the lower so cause loops of fabric surface and out look. 面线间线起珠，引致线步起珠。3 w( D6 M. Z/ v# e0 i; F1.19 Should be 1/4” double needle stitching at cuff ,armhole and front placket.介英/夹圈及前筒应车1/4”双线。 x. d3 z! |, y3 q- Z; o: u1.20 Broken stitching found on waistband/ 裤头断线。$ j- p! E4 _5 A% l: f1.21 Garment have uneven stitching width at front rise/前浪线步不平均。$ Q2 ]: x- L8 K* m1.22 Garment not up to our stitching of 9 S.P.I. /成品未达到每寸9针的标准。* _2 a4 R) f+ o1