hahha（哈哈）.docVIP

hahha（哈哈） The 50 line is the line 50 cm high. It is an auxiliary line used to control the elevation of the structure. 50 lines, 50 lines of construction and 50 lines of structure. The 50 line is used to control the building walls and windows, door position and elevation, ground, ceiling plastering, skirting the elevation. Building 50 lines are generally used to control the structure of concrete pouring elevation. The 50 line is the line 50 cm high. It is an auxiliary line used to control the elevation of the structure. 50 lines, 50 lines of construction and 50 lines of structure. The 50 line is used to control the building walls and windows, door position and elevation, ground, ceiling plastering, skirting the elevation. Building 50 lines are generally used to control the structure of concrete pouring elevation. I am an intern, and the master went to super flat, a total of 12 layers of shear wall frame structure, on the 11 floor to copy 50 lines. Although I practice, many have been in contact with, only the level I can not, mainly fear, fear of mistakes, and simply give up, I do not blame myself, because after the internship does not want to work in the site. Three a good tripod, I put a level up, probably adjusted it with my master said, Im not a good tune, you can. Because the master is more than 50 years old, he seems, who knows he did not look round bubble began to look at the tower ruler, measuring two points, Im looking blisters, blisters that deviated from the center, I said to the master, the master is ah, say a few times, he did not answer me quickly ran downstairs, took up his reading glasses, I am tired of breath up, he also did not measure a few points, I gave him the glasses, he also did not wear, then help the tower ruler out of some problems, he went to see. The Contractor a carpenter also came to help him see the ultra flat, level of my master said, this is some partial blisters ah, after he was one knob leveling in level position, and then rotate an