mss滑移模架施工工艺及技术控制（MSS sliding formwork construction technology and control technology）.docVIP

mss滑移模架施工工艺及技术控制（MSS sliding formwork construction technology and control technology） Proceedings of the fourteenth annual meeting of the society of bridge and structural engineering, Chinese society of Civil Engineering Chinese Institute of civil engineering of bridge and structural engineering institute proceedings of the fourteenth annual conference of the Nanjing Yangtze River Bridge project. Construction technology and technical control of MSS sliding die set Nanjing Yangtze River Bridge 50m bridge construction Liu Jizheng, Qi Lujie, Wang Xiaoshan (Shandong Province Traffic Engineering Corporation, Nanjing Yangtze River Bridge Project Department) [Abstract] this paper briefly introduces the structure and composition of MSS slip and its application in construction. Sliding formwork; construction technology; deflection control I. General Situation of the project Nanjing Yangtze River Bridge North Bridge bridge upper structure for 16m*30m and 5m*50m PC with variable cross section continuous beam bridge. The whole bridge section is composed of two single box and single chamber beam sections separated from top to bottom, and a central partition cover plate is arranged in the middle. among 5 * 50m approach bridge in 30m approach bridge and the main bridge transition section, the bridge is located in land and water, land a hole, four holes on the water, the peak water level 7m. Therefore, it is very important to choose an optimum construction scheme. Two, scheme comparison Based on the bridge position of 50m bridge, two schemes should be adopted for the construction of superstructure: 1. Support construction, set up a full support with one hole on the river bank, insert four hole copper pipe pile in water, and build a steel pipe pile support. Adopt the construction without scaffold. That is, the introduction of foreign advanced equipment - sliding die frame for construction. The first construction plan is the traditional construction method of our company. There are a