不断读取串口mscommlinput数据（Read the serial data to mscommlinput）.docVIP

不断读取串口mscommlinput数据（Read the serial data to mscommlinput） Geotechnical drilling engineering course examination questions library 2 Taking into account the geotechnical drilling engineering lecture is divided into rock drilling process and drilling fluid two major parts, and examination, so here drilling fluid test database single out. Concepts and terminology 1. cation exchange capacity An ion that displaces from clay particles with the same charge, equal amount, etc., usually with mcq/100g. 2. isomorphous replacement In the case does not change the lattice structure, the silicon oxygen tetrahedron in silicon low aluminum ion or iron ion replacement, at the eight surface of aluminum by the low magnesium ion replacement. 3. pulping rate The slurry with a apparent viscosity of 15mPa. S is cubic cubic meter per ton of clay. 4. degree of substitution The extent to which three hydroxyl groups are replaced by sodium carboxymethyl groups in a polymer cellulose link. 5. shear dilution The apparent viscosity of a slurry decreases with increasing shear rate. 6. thixotropy When the mud is still, the clay particles form a structure with each other adsorbed. When a certain shear force is applied to make the mud flow, the structure is disassembled and the fluidity is increased. This property is called mud thixotropy. 7., dehydration, wall sex Under the influence of the liquid pressure difference in the well, the free water in the mud passes through the hole or cranny of the shaft wall and flows into the stratum. It is called the dehydrating of mud. At the same time, the solid particles in the mud are attached to the borehole wall to form mud crust (mud cake), which is called water loss wall forming. 8. aerated drilling fluid The stable dispersion system of gas dispersed in drilling fluid is called aerated drilling fluid. 9. coalescence stability Whether the solid particles in the slurry tend to agglomerate automatically and reduce their dispersion characteristics. 10. plastic vi