阻抗匹配原理（Impedance matching principle）.docVIP

阻抗匹配原理（Impedance matching principle） An article on the principle of impedance matching is introduced: ****************************************************************** The core is that the internal resistance is equal to the external resistance. Here it is equal to the vector because of the capacitance and inductance. ****************************************************************** Impedance matching principle is a common working state in radio technology, which reflects the power transmission relationship between the input circuit and the output circuit. When the circuit achieves impedance matching, the maximum power transmission will be achieved. On the other hand, when the circuit impedance mismatch, not only can not get the maximum power transmission, but also may cause damage to the circuit. Impedance matching is common among amplifier circuits at all levels, between amplifiers and loads, between measuring instruments and circuits being tested, between antennas and receivers, between transmitters and antennas, and so on. For example, between the output circuit and the Speaker Amplifiers must achieve impedance matching, mismatch, output power amplifier will not be sent to the speaker. If the output impedance of the speaker impedance amplifier amplifier is far less than the overloaded, and the last stage power amplifier tube is easy to damage. On the contrary, if the output impedance is higher than the speaker impedance amplifiers too much, will cause the output voltage increases, the same is not conducive to expanding, sound machine, sound will cause distortion. Therefore the output impedance of the amplifier circuit and the speaker, the closer the better. For example, the output impedance of the radio transmitter and the impedance of the feeder, and the impedance of the feeder and the antenna should also be consistent. If the impedance is not consistent, the high frequency energy output from the transmitter will not be transmitted by the antenna. This part o