高层建筑框架梁柱节点的强度验算和施工处理（Strength checking and construction treatment of beam column joints of high-rise buildings）.docVIP

高层建筑框架梁柱节点的强度验算和施工处理（Strength checking and construction treatment of beam column joints of high-rise buildings） Therefore, construction units at least do not want to adopt this method in a large area. 3 shear and compression checking rules Considering the site construction procedures, but also meet the bearing capacity of joint core specification requirements, we gives several examples of typical joints shear, axial compression and eccentric compression are calculated (the attached). The following laws can be obtained by checking computations: 3.1 according to the high regulation appendix C shear seismic calculation, even if the column beam concrete strength was 20MPa, and the joint area with the strength grade of concrete slab, the core zone of the joint section of the shear strength can still meet the requirements. 3.2 in the eccentric compression computation, when the strength grade of concrete beam slab column than low 5MP a, its compressive strength can meet the requirements; when the concrete strength difference between the two 10MPa and above, the compressive strength does not meet the requirements. 3.3 when the concrete strength of beam to column is lower than 10MPa and above, and the beam concrete pouring node area is still used, measures must be taken to the joint area. From the eccentric compression formula N = 0.9 (FC A Corf y A FY A SSO S2 alpha) in 3 numerical compressive, first node section of concrete compressive strength is not changed; third the compressive strength of stirrup provides the proportion of the minimum, and the general design may not change the joints of stirrup specifications; second items is the compressive strength of joints of vertical reinforcement provides a larger proportion, and the use of HRB400 steel (fy=360N/mm2) to increase the vertical reinforcement ratio of joints can significantly increase the compressive strength. 4 construction measures Considering the beam column joint area needs to be processed in the lower part of t