齿轮设计.txt.doc

齿轮设计.txt Design report of involute cylindrical gear drive Design information Designer Name= Li Guangxin Design unit Comp= Xinjiang Agricultural University Design date Date=2011/10/9 Design time Time=22:54:15 Two, design parameters Transfer power P=0.75 (kW) Transmission torque T=4.91 (N = m) Gear 1, speed n1=1460 (r/min) Gear 2, speed n2=230 (r/min) Transmission ratio i=6.35 Prime mover, load characteristic, SF=, uniform, stationary Working machine load characteristic WF= medium vibration Scheduled life H=10000 (hours) Three, layout and structure Structure form ConS= open type The gear 1 is arranged in the form of a ConS1= cantilever arrangement The gear 2 is arranged in a symmetrical arrangement of ConS2= Four material and heat treatment Meshing type of tooth surface GFace= soft tooth surface Quality grade of heat treatment Q=ML Gear 1 material and heat treatment Met1=45 quenching and tempering Gear 1 hardness range HBSP1=217 to 255 Gear 1 hardness HBS1=236 Gear 1 material category MetN1=0 Gear 1 ultimate stress class MetType1=6 Gear 2 material and heat treatment Met2=45 quenching and tempering Gear 2 hardness range HBSP2=217 to 255 Gear 2 hardness HBS2=236 Gear 2 material category MetN2=0 Gear 2 ultimate stress class MetType2=6 Five, gear accuracy Gear 1, group I, accuracy JD11=7 Gear 1, group II, accuracy JD12=7 Gear No. 1, group III, accuracy JD13=7 Gear 1 tooth thickness deviation JDU1=F Gear 1 tooth thickness deviation JDD1=L Gear 2, group I, accuracy JD21=7 Gear 2, group II, accuracy JD22=7 Gear No. 2, group III, accuracy JD23=7 Gear 2 tooth thickness deviation JDU2=F Gear 2 tooth thickness deviation JDD2=L Six, gear basic parameters Modulus (normal modulus) Mn=2 (mm) End face modulus Mt=2.00000 (mm) Helix angle, beta =0.00000 (degree) Base helix angle, beta b=0.0000000 (degree) Gear 1 teeth number Z1=23 Gear 1 modification factor X1=0.00 Gear 1 teeth wide B1=50 (mm) Gear 1 tooth width factor phi d1=1.087 Gear 2 teeth number Z2=146 Gear 2 modification facto