板挠度问题（Plate deflection problem）.doc

板挠度问题（Plate deflection problem） The calculation of the deflection of the consultation board is frequently made, and the problems are concentrated in two aspects: 1: how is the deflection calculated?. 2: Why are some boards not calculating deflections?. Heres a brief introduction: In concrete specifications, there is no specific plate deflection calculation formula. Deflection calculation of PM program is divided into two cases. The first case is that when the plate is a one-way plate, the program calculates the deflection of the plate by exactly the same formula as the deflection of the beam. On the other hand, when the plate is used when the static calculation of two-way slab deflection coefficient in the manual, but will be in the formula of plate stiffness replaced strip stiffness, strip stiffness calculation of reference by calculation with the same beam plate with long-term stiffness. When the slab is a two-way slab, the stiffness B, which is combined with the load effect criterion and takes into account the long-term effect of the load, is used instead of the Bc in the static calculation manual. The bending moment values are the standard combination and quasi permanent combination calculation corresponding to the loading effect, and the quasi permanent load value coefficient program takes 0.5. The program in the calculation of long-term stiffness of plate Bc, approximately X and Y trending across one meter strip are calculated considering different boundary conditions on the edge of the floor, the reference term stiffness calculation formula of beam, the final two direction (X direction and Y direction) long-term stiffness value the smaller as a long-term stiffness of Bc plate. According to the corresponding table plate deflection coefficient and boundary conditions of the plate width significantly static calculation Handbook in the. Just. Degree B shall be obtained according to the relevant regulations of the concrete regulation. For the following cases, the