汽机基础（Turbine foundation）.docVIP

汽机基础（Turbine foundation） 1. Equalizing box action Steam source pressure box from the main steam system and steam system and the front axle seal leakage steam, normally on the front axle seal for the steam leaked steam can meet the pressure of excess steam is discharged into the tank, condenser, the amount is not large, will not affect the vacuum of condenser. Most plants are equipped with shaft seal heaters to recover excess steam from the balance box and condense the water to the condenser The function of pressure equalizing box: adjust steam seal to supply steam pressure, recover surplus steam 2. When the generator sets load rejection, the steam pressure rises, the boiler water level drops, and the steam turbine rotor expands relatively, resulting in negative expansion. Whats the reason?, What is load shedding? The so-called load rejection accident refers to the sudden occurrence of an accident of the whole or part of the load of the steam turbine generator set. The occurrence of load rejection accidents has a great influence on the safety and stability of steam turbines, and it must be paid great attention by the people on duty and related personnel. Turbine generators are mainly the following types: (1) because of the power transmission line suddenly tripping the unit load to the normal output; (2) the development of motor generator protection, jump outlet switch; (3) steam turbine protection, high pressure automatic main steam valve suddenly shut down; (4) in the operation of a an automatic main steam valve, control valve or an oil engine suddenly closed. The first problem: the above situation will cause the turbine inlet amount decreased rapidly, especially in high load, the main steam pressure is more violent rise, even cause the boiler electromagnetic relief valve and safety valve, the steam drum water level due to the corresponding shot up will be decreased rapidly, and even cause low water MFT; when the electrical reasons (above 1, 2 types) caused by the u