砌体交底（Masonry disclosure）.docVIP

砌体交底（Masonry disclosure） Construction technology of aerated concrete block 1, infilled masonry block masonry block should give priority to the use of should be set up skin pole cutting block using special tool. 2, when the product aerated concrete block masonry age should be more than 28 days in advance and 1D 2D on the amount of water block exergy. Should be to moderate watering masonry masonry surface. 3, filling the bottom wall should be used in ordinary brick or small brick or ordinary concrete hollow block cast-in-place concrete ridge Taiwan its height should be not less than 200mm in the GB50203. 4, should not be autoclaved lightweight aerated concrete block masonry mixed with different strength grade and brick concrete block or other materials should not be mixed up. 5, mortar strength grade must meet the design requirements. Masonry mortar shall be vertical and horizontal mortar the plumpness of not less than 80% compacted into concave joint and not a transparent seam, blind sewing, basting. Vertical joints should be used inside and outside the temporary splint seam filling filling wall and frame column, beam contact the mortar masonry must be filled full of and supplyingslurry pointing. The vertical and horizontal mortar seam ash seam width should be 15mm and 20mm respectively. 6 blocks should be staggered, a brick lap length not less than the length of the 1 block 3 exergy and not less than 150mm. If you can not meet the requirements in horizontal seam is arranged in the 2 with 6 or 4 reinforced steel mesh strengthening Rachel reinforced or mesh length should not be less than 600mm. Vertical seams should be less than 2 skin. 7, filling the wall close to the bottom of the beam and plate should be left in the 50 mm certain gap to be filled with heavy wall and at least 7 days interval and @600 wedge squeeze anticorrosion hammer 1 from 3 dry cement mortar mixed with UEA in the dense packing. 8, the length of more than 5m of infill wall should be set from the d