这样很好（Thats fine）.docVIP

这样很好（Thats fine） Good, on flat ground, according to a line has been measured by the bridge foundation pile drilling location. In a loft pile at the same time, should be added in order to check the control of pile construction. Pile and Pile Lofting control are not too short, in the depth of soft soil on the pile of not less than 1m. Two, drilling 1, buried steel tube In the determination of pile position before drilling, accurate buried steel tube, used for fixing the drilling position, improve the isolation surface water, well head to increase the wells of the hydrostatic pressure, the stability of hole wall protection and soil hole collapse to the drilling work. The buried steel tube should pay attention to the following matters: The diameter should be slightly larger than the diameter of the pile casing. By rotating the cone hole, should be larger than the design pile diameter of 15~20 cm. The height of the retaining cylinder can be decided according to the water level, the general high 1, 1.5 cylinder, 2, 2.5 (m) four. In the structure must be sturdy and durable, lightweight, Water Leakage tube. Check in before the deal with the tube diameter buried size, shape, size, gap Water Leakage, connecting pin strong etc.. The buried steel tube shall not be offset according to the pile height, and determined, and should ensure casing center and pile center line, casing wall and vertical to the horizontal plane. The tube positioning should first review of the bridge pier pile. Then in a pile as the center, a vertical cross control pile, the cross center and pile center. The buried depth of casing should be determined according to the underground water level or water level height, the general should ensure that the height of water head tube with 1~1.5m tube, the top surface must be higher than the water level of construction. It protects the tube in place must be accurate, the vertical tube center and pile, wall and horizontal plane (i.e. the cylinder wall and pile center