连杆（connecting rod）.docVIP

连杆（connecting rod） A connecting rod, connecting rod profile (connecting rod) linkage with the two ends of the active and passive components hinged to convey movement and of the bar. For example, in a reciprocating piston compressor and power machinery, with a piston and connecting rod to crank. Connecting rod for steel parts, the main part of the cross section is circular or I-shaped, both ends of the hole, the hole with bronze bushings or needle roller bearings for axle load and a hinged pin. The connecting rod is an important part of the engine, it is connected to the piston and crankshaft, its effect is the reciprocating motion of the piston into the rotary motion of the crankshaft, and the role of the force in the piston to the crankshaft to output power. Link at work, in addition to the gas chamber under pressure, but also bear the vertical and horizontal inertia force. Therefore, the connecting rod in a complex work under stress. It is subject to alternating compressive stress and bending stress. Linkage is the main form of damage and excessive fatigue fracture deformation. Usually the site of fatigue fracture in the connecting rod on the three high stress area. The working conditions of connecting rod for high strength and anti fatigue performance; and has sufficient rigidity and toughness. A typical machining machinery manufacturing in the process of connecting rod. The traditional processing technology of connecting rods of the material in general use 45 steel 40Cr or 40MnB steel, but now the foreign advanced connecting rod cracking which is widely used (conrod fracture splitting) processing technology requirements of the high brittleness and high hardness, therefore, a new connecting rod material German car production such as C70S6 high carbon micro alloy non SPLITASCO series of quenched and tempered steel, forged steel, FRACTIM steel and S53CV-FS steel forging forging (all the German DIN standard). Although the strength of high alloy steel, but is very se