钢网架结构安装工艺标准(507-1996)（Standard for installation of steel grid structures (507-1996)）.docVIP

钢网架结构安装工艺标准(507-1996)（Standard for installation of steel grid structures (507-1996)） Range The process standard is applicable to the installation of steel grid structure, high altitude bulk method, high altitude slip method or ground assembly, overall lifting (lifting) and so on. Construction preparation 2.1 materials 2.1.1 steel grid installed steel and connecting materials, high-strength bolts, welding rod, welding wire, flux and so on, should comply with the design requirements, and should have factory certificate. Hollow welded ball, ribbed welded ball and bolt ball for installation of 2.1.2 steel grid. Semi-finished products, small units, bars, and rubber bearings and other semi-finished products should comply with the design requirements and the corresponding national standards. 2.2 main machines and tools: Electric welding machine, oxyacetylene cutting equipment, grinding wheel, cutting lathe, sawing rod rod cutting power head, steel tape, steel ruler, caliper, level, theodolite, ultrasonic flaw detector, magnetic particle detector, lifting equipment, lifting equipment, hammer, steel wire brush, hydraulic jack, chain other tools. 2.3 operating conditions: Before installing the 2.3.1, check the axis and the elevation of the support frame of the network. The axis and elevation of the grid must comply with the design requirements and the relevant standards. 2.3.2 before installation should check the strength of concrete columns, column concrete strength must be compatible with the existing provisions of relevant standards and design requirements of countries, in order to install. When the 2.3.3 uses the high altitude slip method, the sliding track pulley should be checked, and the slip horizontal slope should meet the requirements of the construction design. When the 2.3.4 is installed with bars and blocks, the sliding table shall be checked and the test run shall be carried out when the worktable slides. 2.3.5 by lifting the overall or partial lifting time, dea