螺杆式冷水机(例行保养)检查报告.docVIP

Jan 1月 ( Feb 2月 ( March 3月 ( April 4月 ( May 5月 ( June 6月 ( July 7月 ( Aug 8月 ( Sep 9月 ( Oct 10月 ( Nov 11月 ( Dec 12月 ( RTHB Series R(螺杆式 冷水机(例行保养)检查报告 Service Excellence North China Service Customer Job Name 客户工程名称 Maintenance Date 保养工作日期 M/D/Y (月/日/年) Trane Job Number 公司工程编号 Job address 工程地点 Unit Model # 机组型号 Unit Serial # 机组出厂编号 The Following Procedures Must be Performed by a Qualified Experienced Trane Service Technician. 以下检查程序项目必须由有经验、有资格的特灵服务技术人员完成 No Monthly Maintenance Procedures (Unit Run)运行期间例行保养程序 ( 机组切断供电电源情况下,进行检查的项目部分 NO POWER SUPPLY WARNING: Disconnect All The Electric Power Including Remote Disconnects Before Servicing. Failure To Disconnect Power Can Cause Severe Personal Injury Or Death. 注意:检测前保证确实断开所有电气电源包括远端电源开关.否则可能引起人员伤亡. 1 机组压缩机电机部分 Compressor/Motor 1 检查及收紧压缩机电机电源端子Check tight all terminal of motor 2 检测电机三相线圈温度传感器欧姆值Test ohm value of the coil temp. sensor 1-4 ______ ( 2-4 ______ ( 3-4 ______ ( 3 检测电机三相线圈之绝缘阻抗测试Megger test of the motor T1 To Earth ____ M( T2 To Earth ____ M( T3 To Earth ____ M( T4 To Earth ____ M( T5 To Earth ____ M( T6 To Earth ____ M( T1 To T2 ____ M( T1 To T3 ____ M( T2 To T3 ____ M( T1 To T4 ____ M( T2 To T5 ____ M( T3 To T6 ____ M( 4 实测环境温度 Test ambient temperature 环境温度 ambient temperature _________________F/(C 2 机组压缩机电机启动器箱部分Starter Panel of Compressor/Motor 1 检查及收紧机组启动器箱内所有之电源接线端子 Check tight all of terminal of power 2 检查及收紧启动器箱内所有控制接线端子 Check tight all controlled terminal 3 检测压缩机电机起动器内之所有其它电气装置 Check all auxiliary terminal 4 检查电磁接触器部分 Check the contact of the contactor 检查启动器箱内所有电磁接触器触点状态 Status of the contactor 良好 fine 可接受 suitable 建议更换 suggest to change 清洁启动器箱内所有电磁接触器接触器触点,线圈,衔铁等部件 Clean the contactor 检查运行/短路电磁接触器机械互锁 Check running/short contactor mechanical interlock 5 清洁/除尘机组压缩机启动器箱 Clean the starter panel 3 机组控制机械部分 Controlled/Mechanical Parts 1 检查及调整冷却水及冷冻水流量/压差开关 Check Adjust cooling water ch