新时达f参数说明（Step f parameter description）.doc

新时达f参数说明（Step f parameter description） Motherboard parameter description (with no parameter classification operator used) Parameter, parameter, meaning, remark, factory value, unit read 0 acceleration slope adjustment start acceleration 550 mm/s2 0.55m/ S2 1 deceleration slope adjustment braking deceleration 550 mm/s2 0.55m/ S2 2 S curve T0 start initial S bending angle time 1300 0.01s 1.300s 3 S curve, T1 acceleration, S bending time 1100 0.01s 1.100s 4 S curve, T2 deceleration, initial S bending time 1100 0.01s 1.100s 5 S curve, T3 deceleration end, S bend angle time 1300 0.01s 1.300s 6 elevator rated speed elevator calibration value 1750 mm/s 1.75m/s 7 motor rated speed motor nameplate value 1450 rpm 1450rpm 8 encoder pulse number encoder after PG card frequency division each revolution pulse number 1024 PPR 1024ppr 9 lock ladder, base station, lock ladder, return base station 1 10 bias layer 0 11 preset total number of plies installed in hoistway 18 12 overhaul speed, maintenance speed of 250 mm/s 0.250m/s 13 back leveling speed, automatic leveling layer, the speed of 60 mm/s 0.060m/s 14 closing delay 1 response to the call, stop the ladder, open the door to maintain the time 30 0.1s 3.0s 15 closing delay 2 response to internal election stop when the door open hold time 30 0.1s 3.0s The 16 gate delay from the signal given to the governor operation began to open the brake delay time of 2 0.1s 0.2S 17 removal operation started to remove brake delay from the governor operation signal delay time of 6 0.1s 0.6s 18 fire base station fire status returned base station 1 19 second fire station 1 20 delay base time 0: no delay, immediately back to the base station. 0 s 0s 21 leveling error, distance from lift, single deck operation and multi-layer operation, leveling error correction, 6, mm, 6mm When the 22 is in parallel, the first base station is connected by a first base station in parallel (see F20, F196, F197) 1 23 parallel mode 1: parallel ladder (compatible with th