施工员试题精选（Selection of builders questions）.doc

施工员试题精选（Selection of builders questions） Selected works of construction workers (1) C Test Editor: Hot thea update: June 18, 2012 [comment] I. radio questions: L, a trench by slope excavation, the slope is l:0.25, such as the foundation width is 800mm, depth of 2m line size (C). A 800, B 1300, C 1800, D 2800 2, gravel or blasting ballast as filler, the maximum diameter of each layer shall not exceed the paving thickness (A). A 2 / 3, B, L / 2, C 2 / 5, D 1 / 3 3, the masonry of the central axis allows for bias (D) mm. A 20, B 15, C 12, D 10 4, when the scaffold adopts lap joint laying, its lap length should be greater than (B) mm. A 200, B 300, C 400, D 500 5. One of the quality requirements of electroslag pressure welding is that the axial deviation shall not be greater than (D) the diameter of the reinforcement and shall not be greater than 2mm. A 1 / 2 B L / 4 C L / 8 D 1/lO 6. The spacing between the ends of the reinforcement joint and the bending point of the steel bar shall not be less than (C) times of the diameter of the steel bar. A 15, B 12, C 10, D 8 7, the cranes three main working parameters are (C). A motor power, lifting height, working range, B lifting height, working range, maximum lifting weight C lifting capacity, lifting height, working range, D lifting height, working range, motor speed 8, in order to control plastering smoothness and perpendicularity should be (C). A hanging line, B elastic line, C made Grey Cake, punching rib, D layered plastering 9, paint brushing should be (C). A dip dipped in each brush, B dipped in long brush, C dip dipped in long brush. D brushing at will 10, when the roof slope is within 3 to 5%, the C can be laid on the ridge of the roof. A parallel, B vertical, C parallel or vertical, D arbitrary 11, the degree of wall construction joints should stay in the outer surface of the floor above not less than (A) mm. A 300, B 200, C 150, D 120 12, winter construction mixing mortar should adopt two step feeding method. The te