boundary stabilization of memory type for the porous-thermo-elasticity system边界为porous-thermo-elasticity系统稳定的内存类型.pdfVIP

Hindawi Publishing Corporation Abstract and Applied Analysis Volume 2009, Article ID 280790, 17 pages doi:10.1155/2009/280790 Research Article Boundary Stabilization of Memory Type for the Porous-Thermo-Elasticity System Abdelaziz Soufyane,1 Mounir Afilal,2 and Mama Chacha1 1 College of Engineering and Applied Sciences, ALHOSN University, P.O. Box 38772, Abu Dhabi, United Arab Emirates 2 Departement Mathematiques Informatiques, Faculte Polydisciplinaire de Safi, Universite Cadi Ayyad, ´ ´ ´ ´ Route Sidi Bouzid, BP 4162, Safi 46000, Morocco Correspondence should be addressed to Abdelaziz Soufyane, asoufyane@ Received 10 January 2009; Accepted 14 March 2009 Recommended by Irena Lasiecka We consider the one-dimensional viscoelastic Porous-Thermo-Elastic system. We establish a general decay results. The usual exponential and polynomial decay rates are only special cases. Copyright q 2009 Abdelaziz Soufyane et al. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. 1. Introduction An increasing interest has been developed in recent years to determine the decay behavior of the solutions of several elasticity problems. It is known that combining the elasticity equations with thermal effects provokes stability of solutions in the one-dimensional case 1. Several results concerning the exponential or the polynomial decay of solutions for the thermoelastic systems were obtained by 2–6. A sample model describing the one-dimensional porous-thermo-elasticity, which was developed in 7, 8, is given by the following system: