design of a control device for synthetic making test based on pre-arcing current detection and phase control设计合成的控制装置使测试基于pre-arcing电流检测和相位控制.pdfVIP

J. Electromagnetic Analysis Applications, 2009, 1: 279-283 279 doi:10.4236/jemaa.2009.14043 Published Online December 2009 (http://www.SciRP.org/journal/jemaa) Design of a Control Device for Synthetic Making Test Based on Pre-Arcing Current Detection and Phase Control 1 1 2 Zhengyang ZHOU , Minfu LIAO , Xingming FAN 1Department of Electrical and Electronics Engineering, Dalian University of Technology, Dalian, China; 2School of Mechanical of Electrical Engineering, Guilin University of Electronic Technology, Guilin, China. Email: zhouzhengyang123@ Received July 22nd, 2009; revised August 12th, 2009; accepted August 20th, 2009. ABSTRACT The synthetic making test has been widely used in evaluating the break ability of high-voltage circuit breaker. However, the test research and application are still inadequate, especially in the condition of rated voltage. According to the re- alistic conditions of test stations in China, a control device based on pre-arcing current detection and phase control is proposed in this paper. A sample of the control device made up of DSP TMS 320LF2407A is fabricated, in which the CPLD MAX7064 is used to transmit signals for EMC design. It can be applied in full voltage synthetic making test at a level of 126kV/63kA. The test results show that, it is accurate to control the making phase of the applied voltage, whether the closing is demanded at voltage peak or zero. Keywords : Synthetic Making Test, Pre-Arcing Current, Phase Control 1. Introduction It is well recognized that the verification of the making synthetic making test at 245kV/63kA [1], and the ABB ability of circuit breakers is an integral part of the certi- Company at 362kV [6]. On the basis of realistic condi- fication procedure. A