design of adaptive filter using jordanelman neural network in a typical emg signal noise removal设计自适应滤波器使用jordanelman神经网络在一个典型的emg信号噪声去除.pdfVIP

Hindawi Publishing Corporation Advances in Artificial Neural Systems Volume 2009, Article ID 942697, 9 pages doi:10.1155/2009/942697 Research Article Design of Adaptive Filter Using Jordan/Elman Neural Network in a Typical EMG Signal Noise Removal V. R. Mankar1 and A. A. Ghatol2 1 Electronics Department, Government Polytechnic, Amravati, (M.S.) 444 604, India 2 Technological University, Lonere, Dist. Raigarh, (M.S.), India Correspondence should be addressed to V. R. Mankar, vr mankar@rediff Received 28 July 2008; Revised 24 November 2008; Accepted 3 February 2009 Recommended by Yasar Becerikli The bioelectric potentials associated with muscle activity constitute the electromyogram (EMG). These EMG signals are low- frequency and lower-magnitude signals. In this paper, it is presented that Jordan/Elman neural network can be effectively used for EMG signal noise removal, which is a typical nonlinear multivariable regression problem, as compared with other types of neural networks. Different neural network (NN) models with varying parameters were considered for the design of adaptive neural- network-based filter which is a typical SISO system. The performance parameters, that is, MSE, correlation coefficient, N/P, and t, are found to be in the expected range of values. Copyright © 2009 V. R. Mankar and A. A. Ghatol. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. 1. Introduction CRO and loudspeaker the action potentials spontaneously present in a m