Ti-6Al-4V合金在真空中的干滑动磨损行为.pdfVIP

VoJ.39 No.7 第 39 卷第7 期 令品专Jt. 20臼年 7 月 711-714 页 ACTA METALLURGlCA SINICA Ju}y 2∞3 pp .711- 714 Ti-6Al-4V 含金在真空中的干滑动磨损行为* 刘勇杨德庄何世禹武万良 (哈尔滨工业大学空间材料与环镜工程实验室，哈尔滨 1ω∞1) 擒 ~ 在.空 (lO-S Pa) 条件下~f Ti-6AI-4V 含金进行了系统的磨损性能测试.研究7裁街和滑动速度对 Ti-6AI-4V 合金摩领事的影响Jtt Tí-6Al-4V 含金的磨损表面进行了显11:组织分析. ~峻结果表明. Ti-6Al-4V 含金的廖损.$黯舷街和 滑动越度的升高而地加.黯损表面.具有层状结构的舌状形~.符征， 分析表明这是 TI-6AI-4V含金我茵通过接触点处材斜的.推 销和银压过程形成了待殊的变形堆砌层的结来.显微组织分析显示.这种变形堆砌层具有民)-100 nm 尺寸的细小显徽组织结构 利 50mm 以主的厚度. 关.词怯含金.干t雷动.M捕，显微组织，变形，真空 中回法分类号 TG146.23, TG115.58 文献标i.RE马 A 文ø编号 0412咀1961(2003)07- 0111- 04 DRY SLIDING WEAR BEHAVIOR OF Ti-6Al-4V ALLOY IN VACUUM LIU Yong, YANG Demuang, HE Shiyu, WU Wanliang Sp属e Ma.teria.ls a.nd Environment Sngin帽ring Laboratory, Ha.rbm lMtitute of Technology. Harbin 150ω1 Con-espondent: LIU Yo呵， Tel: (0../51)6412../62, E- mail: yongliu @pubhc.hr.hl.cn Supported by N础。nal Key B ll3 ic R.esea陀h and Development Programme 01 α饥a (NO. GI9990650) Maouscrì p received 2002-那-16， in revised form 2002冲谷 ABSTRACT The effeçts ofload and sliding velocity on the wear rate ofTi-6A 1-4V alloy in vacuum (10-5 were studi时， and tb e microstructural analysis of the wom surf:础。f THìAl-4V alloy 附e 问 carried out. The r esuJts show that the wear rate of Ti-6AI-4V alloy incr自由es with increasing the load and sliding velocity. The worn surface 巳 cha.racterized by a step-like morphology with the layered structure, which is a result of forming a speciaj deformed--stacked layer due to puslúng a.nd rolling of material at t he coot açting spot of th e T • 6AJ-4V alloy. Microstructural a.nalysis indiωte哩 that the S伊called deformed咱tacked la.yer presents a fìne mic