tingting（婷婷）.docVIP

tingting（婷婷） The plywood is logs into veneer or by wood sliced veneer, with adhesive glued into three or more layers of sheet material, usually with odd veneer, and the fiber direction of adjacent plates perpendicular to each other and gluing. Plywood with wood as the main raw material for the production of plywood, the fine processing and production process of its rationality in the structure, can largely overcome the wood defects greatly improve and enhance the physical and mechanical properties of wood, plywood production is an important way to make rational use of wood, improve the properties of wood. An artificial board made of lignocellulosic fibers interwoven and formed with inherent adhesive properties. Adhesives and / or additives may be applied in the manufacturing process. Fiberboard has many advantages, such as uniform material, little difference between longitudinal and horizontal strength, not easy to crack and so on. It takes about 2.5 to 3 cubic meters of wood to produce 1 cubic meters of fiberboard, instead of 3 cubic meters of wood or 5 cubic meters of logs. Developing fiberboard production is an effective way of comprehensive utilization of timber resources. The disadvantage of the fiber board is that the back surface has reticulate patterns, resulting in unequal surface areas of both sides of the sheet material. After the moisture absorption, the plate is warped and deformed due to the expansion force difference; the hard board surface is hard, the nail is difficult to nail, and the water resistance is poor. Although the dry process fiberboard avoids some shortcomings, the cost is higher. Wood keel is still the most commonly used home decoration skeleton materials, according to the use of parts to be divided, wooden keel Can be divided into ceiling keel, vertical wall keel, floor keel and hanging keel. Wooden keel is the biggest advantage of cheap and easy construction. But wooden keel itself also has a lot of problems, such as flammable, easy to