结构设计注意事项（Notes on structural design）.docVIP

结构设计注意事项（Notes on structural design） Considerations for structural personnel in design The following is our hospital to structural personnel in the design of notes, are sent up for your reference!!! 2000 series of new specifications early implementation of structural design considerations According to the Ministry of construction requirements, from January 1, 2003 onwards, the full implementation of the new norms, the corresponding 89 series of norms abolished. In order to correctly understand and effectively implement the relevant 2000 series of specifications, the following key points are raised, and the structural designers should pay attention to them: I. General Provisions 1, the design instructions should indicate the engineering design life, safety level, selection of building materials, should be marked specifications, models, performance and other technical indicators, the quality must meet the requirements of the national standards. 2 and 2003 signed the contract design projects, will be used in accordance with the new specifications of the software for calculation and analysis, TBSA with 6 edition, SATWE with 2003.1 and later version. 3, with the new version of software calculation results, steel will be improved, our institute provides a new version of software to calculate the beam, column main reinforcement, steel priority HRB400. Primary column stirrups shall be preferentially adopted by HRB400. 4, wind load value, Nanjing region design cycle 50 years, W0 = 0.40Kpa, design cycle 100 years, W0 = 0.45, wind sensitive buildings, and more than 60 meters tall building according to W0 = 0.45 value. 5, basic snow pressure, 50 years in Nanjing area, the design cycle of 0.65Kpa, the design period of 100 years from 0.75Kpa. 6, the definition of small towers should be careful when the height of the tower to the building proper height effect, small tower should be reported to determine the structure of Institute of Specialized Committee. 7, construction plans inv