SS120 CertiShine Specification 313（SS120 CertiShine规范313）.pdf

SS 120 1-13 Section 03 35 43 Polished Concrete Finishing Specifier Note: This product guide specification is written according to the Construction Specifications Institute (CSI) 3-part format. This section must be carefully reviewed and edited by the Architect or Engineer to meet the requirements of the project and local building codes. Coordinate this section with other specification sections and the drawings. Delete all “Specifier Notes” when editing this section. Specifier Note: This suggested specification is designed for existing or new hardened concrete. Concrete for new construction should be specified under Section 03 30 00 (cast in place) for curing, mix design, compressive strength, finish troweling, and floor flatness tolerances. Vexcon can assist with modification of your existing 03 30 00 specification with emphasis on the n sections above and other pertinent sections for designing a concrete floor for polishing. Specifier Note: This guide specification is provided as a start point for the design professional. o Any modifications to the specification are the responsibility of the design professional. Contact s Vexcon Chemicals with any questions regarding this product. l c PART 1 – GENERAL x a 1.01 SECTION INCLUDES A. Penetrating Liquid Floor Treatment for Polished Concrete Finishes: Clear, c chemically reactive, water borne solution of silicate material and