装电脑（Install a computer）.docVIP

装电脑（Install a computer） [hand]: teach you step by step to install a computer I dare not say that advice, just want to share, learn together about ^_^ Its easy for a master to assemble all kinds of accessories into a computer, but for most people who first contact the computer, thats not the case. For many readers who want to learn how to assemble and understand the DIY knowledge of computer assembly, how can we assemble all kinds of computer accessories into a complete computer? First, the preparation before the installation 1, tool preparation As the saying goes, work is good to do things, they must first benefit the device, there is no easy tool, the installation will become troublesome, then what tools are installed before you need to prepare? (see Figure 1, from left to right pliers, paste, cross knife, flat knife solution solution) Figure 1 The solution: cross cross knife knife and a screwdriver, said the solution of a screwdriver or a screwdriver, for removing and installing screw tool. Since all the screws on the computer are all cross shaped, you just have to prepare a cross screwdriver. So why prepare a magnetic screwdriver? This is because the computer device is smaller after installation, and once the screws fall in it, it is very troublesome to take them out. In addition, the magnetic screwdriver can also suck screws and installation is very convenient, so the computer using a screwdriver, most of them have permanent magnetism. Flat knife: flat mouth solution knife, also known as one type of knife solution. How can you also prepare a flat knife, not only easy to install, but also can be used to disassemble the product packaging boxes, packaging seals and so on. D: you should also prepare a large medical forceps that can be used for holding screws, jumpers, caps, and other small bits and pieces. Pliers: pliers in the installation of the computer is not very useful, but for some of the poor quality of the case, the pliers will also come in handy. It can be