cad问题（CAD problem）.docVIP

cad问题（CAD problem） 79 CAD small problem solutions (1) 1. [CTrl+N invalid solution] As everyone knows, CTRL+N is a new command But sometimes, CTRL+N appears the selection panel At this point, just set the settings in the OP option Operate: OP (options) - System - - there is a start on the right (A display, start dialog, B does not display the start dialog) When you select A, the new command is valid, and the reverse is invalid 2. [Ctrl key invalid solution] Sometimes we have problems like this For example, CTRL+C (copy), CTRL+V (paste), CTRL+A (Quan Xuan) and a series of commands related to the CTRL key will fail At this point, you just need to tune in to the OP option Operation: OP (option) - user system configuration WINDOWS standard accelerator (tick) WINDOWS standard accelerator tick, and CTRL key commands is effective, and failure 3. [fill invalid solution] Sometimes filling will not fill out In addition to system variables that need to be taken into account You also need to check in the OP option OP - display application entity filling (tick) 4. [solution of invalid election] The correct setting for AD should be to continuously select multiple objects But sometimes, the continuous selection of objects will be invalid, you can only select the last selected object This can be resolved as follows Enter the OP (optional) - select the SHIFT button added to the choice set (to remove the hook) Add the SHIFT key to the selection, and then add select after remove the tick On the contrary, the selection is invalid Command: PICKADD value: 0/1. 5. [CAD] ordered three reduction If the system variables in CAD are unintentionally changed Or some parameters have been deliberately adjusted, what should I do? At this time, there is no need to reinstall, nor do you need one change at a time Operate: OP option - configuration Reset Can resume But after recovery, some options also need some adjustments, such as cross cursor size, etc. ~! 5. [mouse middle key is not good, how to do