教您如何木蜡油diy（Teach you how to wax DIY）.docVIP

教您如何木蜡油diy（Teach you how to wax DIY） A detailed description of the construction of wood wax oil, long ago intended to do it personally, pat to the pro reference, under The surface is about hardwood types used in wood wax oil, because it is done by one person, so some Pictures can not be photographed, but some key parts for your reference, followed by the process. Timber: Fraxinus mandshurica, size 500mm*12mm (Figure 1) The finished effect picture, the board forgot to shoot Tools needed for construction (Figure two) Surface treatment Hardwood wood (including veneer), common oak, walnut, ash, elm Catalpa wood, cherry wood... Judge hardwood methods: 1. look, the general hardwood, its pores Coarse hardwood leaves are generally broad leaves, not needles (the leaves of pine); 2, nails Make a mark of wood, details, namely cork. 3, the weight of the average hardwood heavier. Home improvement in the hardwood encountered in general are solid wood (including finger board, laminated wood) and solid wood skin (bag) Veneer panel Grinding is usually based on the roughness of the wood surface to determine the use of sandpaper model, general It is sanded with 180#--240# sand paper, follow the direction of wood grain to burnish (the solid wood that sells on the market table) Most surface is through simple grit or planing, buy a home only need to use 180# to the surface of the belt Coarse sand mark and burr) some wooden friends prefer sanding with very fine sandpaper (400# or more) Sand paper) I dont think its necessary. Hardwoods are generally polished enough to use 320# sandpaper The key is to remove the burr and sand mark on the wood surface!!! (Figure three) Sanding along the grain direction (Figure four) This picture shows some sand marks, especially on the surface of the wood. This is due to 180# Sandpaper is not thoroughly polished (Figure five) The picture clearly shows burrs and sand marks on the surface of the wood, while burrs and sand marks are Surface problems to be solve