梁柱设计经验（Liang Zhu design experience）.docVIP

梁柱设计经验（Liang Zhu design experience） Liang Zhus design experience,.Txt, if you see the shadows in front of you, dont be afraid, its because you have sunshine behind you! I allow you to walk into my world, but never allow you to walk around in my world. Liang Zhu.Txt12 design experience missing is a poem to let you in ordinary days to read out the rhythm; missing is a shower, let you dry up the moist days; missing is a sun, so that your days of gloomy clear up. I. design of beams 1. beam size determination. The project is vertically and horizontally loaded, mainly laterally loaded, initially determined according to the beam size: The H: (1/8 - 1/12) L, B (1/3 - 1/2) wide H Linking Liang Gaoh: (1/10-1/15) L, wide B (1/3-1/2) H The secondary beam to: (1/12-1/18) L, B (1/3-1/2) H wide 2 I quote some experience in beam design here: (1). Beam position (including the cantilever beam ends) should be attached stirrups and hanger, should give priority to the additional stirrups. The beam and column under the water tank, frame on plate beam, does not need to add additional reinforcement. Can be painted at the structural design of the general office of a node, there are secondary beams on both sides of each additional three main beams stirrups, load larger, detailed construction drawings. (2) when the span of the exterior beam is not big, the height of Liang Gaoyi is high, especially the outer frame beam. When the distance between the bottom of the beam and the outer window is small, the beam height should be increased to the top of the window. The outer frame beam shall be made as far as possible, and the outer skin of the beam shall be flush with the cylindrical skin. When the building is required: a column beam can be offset while a smaller size. Eccentric beam column may be greater than the column width of 1/4, and the column width is less than 1/3. (3) when the angle of the folded beam is lower, the longitudinal reinforcement should be broken and anchored into the compressi