水管管径（Pipe diameter）.docVIP

水管管径（Pipe diameter） Four in charge and six in charge of diameter 2009-10-26 13:42 1 inches =25.4 mm =8 British cents 1/2 is four points (4 English points) DN15 3/4 is six points (6 English points) DN20 2 in charge of DN8 4 in charge of DN15 6 in charge of DN20 1 DN25 1.2 DN32 1.5 DN40 2 DN50 2.5 DN65 3 DN80 4 DN100 5 DN125 6 DN150 8 DN200 10 DN250 12 DN300 GB/T50106-2001 2.4 pipe diameter 2.4.1 the pipe diameter shall be mm. 2.4.2 pipe diameter shall be expressed in accordance with the following provisions: 1, water gas pipe (galvanized or non Galvanized), cast iron pipe and other pipe, the diameter should be nominal diameter DN; 2 seamless steel pipe, welded steel pipe (straight seam or spiral joint), copper pipe, stainless steel pipe and other pipe, the diameter should be expressed by outer diameter * wall thickness; 3 reinforced concrete (or concrete) pipe, clay pipe, acid resistant ceramic tube, pipe and other pipe diameter should be gangwa, with inner diameter of D said; 4 plastic pipe diameter should be expressed according to the standard method of products; 5 when the design of nominal diameter DN means diameter, should be nominal diameter DN and the corresponding product specifications table. Specification for unplasticized polyvinyl chloride pipes for building drainage, de (nominal outer diameter) * e (nominal wall thickness) (GB, 5836.1-92) Specification for polypropylene (PP) pipe for water supply is expressed in de * e (nominal outside diameter * wall thickness) With the improvement of peoples living standards, environmental awareness and health concerns, a green revolution has been launched in the field of water supply and drainage. According to a large number of water quality monitoring data show that: after the use of cold galvanized steel pipe, the general service life of less than 5 years of corrosion, iron smell is serious. Residents complain to the government, creating a social problem. Compared with the traditional metal pipe plastic pipe, has th