汽车用膜_恒达（With the film _ Hengda car）.docVIP

汽车用膜_恒达（With the film _ Hengda car） A film grade classification for automobiles At present, the automobile film on the market can be divided into four grades: The first is the dying film, which is commonly called the ordinary film, ordinary chemical film is the main component of dyeing with adhesive, the insulation film is like paste together with the lamp glass paper, neither heat insulation, anti ultraviolet radiation, nor not explosion-proof. The second is a semi reflective paper, which is usually given to users by car dealers, with a heat insulation rate of about 20% to 30%. After one or two years of use, the surface will react with oxidation to cause deterioration. Explosion-proof insulation film, third reflection infrared with a metal layer of coated with wear-resistant, semi reflective and explosion-proof function, ultra-thin metal coating can choose the infrared reflecting sunlight in the back, which has a thermal insulation function (infrared heat source, heat insulation is) rate can reach more than 50%. This is the main type of high-grade explosion-proof insulation film. Fourth, explosion-proof insulation film using non metal layer insulation, using non metal layer insulation explosion-proof membrane: the insulation film highest technology types, such as unlimited scenery is the 3M, without the use of metal coating infrared reflection, but the use of polymer material as insulation, good heat insulation film is high light transmittance. And the glare of the isolation effect is very strong, the heat rate is also very good, is not easy to cause the front windshield of the reflector, so that the drivers driving safety has improved a lot. B automobile film performance index I. transmittance and clarity of membranes This is the vehicle in the film about the performance of vehicle safety is the most important, it is recommended that users try not to select the transmittance of the film is too low, the window film, especially on both sides of the front window film