E+H压力显示仪表VU30英文操作手册.pdfVIP

BA 008P/00/en/06.98 015299-0001 Cerabar Display VU 130 Instrument The Cerabar display VU 130 is specially designed for the Description Cerabar pressure transmitters PTC or PMC with the synthetic housing. The Cerabar VU 130 display for the PMC version can be plugged onto all pressure transmitters with a 4...20 mA or 0...20 mA analogue output. The Cerabar VU 130 display for the PTC version can be plugged onto pressure transmitters with a PNP or NPN switch output. The display module is plugged onto the Cerabar housing in place of the housing cover. It has Protection IP 65 as standard. This on-site display must not be installed in an explosion hazardous area! The measured value is displayed in two ways. For quick assessments, the measured value is displayed quantitatively as a half-circle bargraph with 40 segments corresponding to the 0/4...20 mA signal or the voltage signal (PTC). If the end value is exceeded (Imeas 20 mA), then the bargraph flashes a warning. For more accurate determination, a 31/2 digit LCD display gives values with a display range from –1999 to +1999. It is preset to the technical units required (e.g. bar). If this display range is exceeded then the last three digits are blanked out (« 1 » instead of « 2000 »). Mounting Remove the housing cover from the Cerabar Wire up the display to the terminal strip of the Cerabar (refer to Electrical Connection