气割要领（Cutting Essentials）.docVIP

气割要领（Cutting Essentials） Gas cutting Thought: the flame cutting essentials of iron hot baked into liquid iron with high pressure oxygen flow chemical reaction of ferric oxide powder in high temperature and high pressure under the catalysis (Fe+O2=Fe2O3) after being part of the high-pressure oxygen flow blowing The 10 step: cutting process in order to adjust spacing -- blow force direction, adjustable table - cloth tube - check tightness - rust - open gas ignition - - gas preheating secant blowing force -- adjustment of gun nozzle and workpiece - blowing broken A basic knowledge of cutting. 1, cutting principle: A, high temperature oxygen and acetylene combustion using molten metal (temperature). B the oxygen stream blows off the metal combustion (oxygen flow, air flow, blowing). C the heat released by metal combustion is characteristic of conduction below metal. 2, cutting conditions: A, is cutting the metal melting point must be higher than the ignition point. B, the heat conductivity of metals is low. C, the metal carbon content, impurities less, so the metal can only be low carbon steel. Stainless steel, copper, aluminum, alloy in cutting will produce High melting point oxide film, so it can not use oxyacetylene cutting. 3, the role of oxygen: to provide suction to acetylene, molten iron to provide blowing force, and acetylene burning together, resulting in high temperature, high heat. Two, cutting tools 1, decompression table (commonly known as: oxygen table, acetylene table): through the pressure reduction table gas will be reduced gas pressure to the required stability of the gas working pressure. For decompression tables, the left side is low, and the right is high pressure. Vacuum pressure gauge =1.5 MPa pressure flow meter =1.2--1.5m3/t, oxygen bottle must leave =0.3 trillion guarantee radio absorption and deforestation work taking place - tempering. 2, gas path: red tube is oxygen tube, black or green tube is acetylene tube. 3, cutting moment: commonly kno