电容好坏的测量（Measurement of capacitance）.docVIP

电容好坏的测量（Measurement of capacitance） Measurement of the quality of capacitors.Txt Measurement of capacitance Capacitors, good or bad There are 4 kinds of capacitor damage: 1. short circuit, 2. non capacity, 3. capacity reduction, 4. stability 1. needless to say 2. filter according to the voltage and the phenomenon of 3. experience the most difficult to estimate the equivalent capacity must also consider the time factor of 4. most associated with the leakage of peeling bulging head phenomenon, the thermal stability of poor cooling is a good way to use alcohol The quality of the capacitor is really bad for the road. Most of the actual operation of capacitor breakdown, leakage current, stability is not good from the appearance or temperature Shenglai judgment, sometimes using the electrical measurement to confirm the voltage; for large capacitance circuit, first through the analysis of the failure phenomena and circuit, suspected remove measurement, small capacitor number by and connected to the test judge. Its OK to use a digital watch or a capacitor meter, but its better to replace it directly. Sometimes its good but it doesnt work. Pointer table X10K ohm gear measurement, pointer swing slightly, and then point to infinity. Sometimes the measurements are normal, but they are not available on the computer. Its better to test with a capacitor meter, but not with a universal watch! The model is pps512j 1600V and the other is 822j pp800v You should pay attention to pressure: you are the first 1600 Volts 5100 micro method 800 Volts 8200 micro method Youd better replace it. If the circuit requires high voltage, it must not be too small You can also use a multimeter to compare the same capacitance, see if the pointer swings, the biggest resistance. First of all, you can see whether the capacitor has no drain or capacitor, and there is no upward convex, which is the most direct method, if not. Replace or replace with a capacitor. When replacing, pay attention to the size of t