电源系统（power supply system）.docVIP

电源系统（power supply system） Leakage protection knowledge electronic 2009-05-06 12:49:49 read 346 comment 0: big and small How can the single-phase leakage protector enter the line? Household electricity, 60 ann. Single phase leakage protector, how to enter the line, is left, zero, right fire, or left fire right zero? Answer: national industry standard power supply wiring is: left, zero, right fire, switch socket is the same. In addition, look at the logo: L for the FireWire; N is zero line. Install the upper side of the power supply, the lower side of the load. Where does the family need to install an electric leakage protector? The total open is not necessary with leakage protection, lighting without leakage protection switch, socket must through the leakage protection switch. The family installed, in addition to outside suggestions will be lighting electrical access, because when the electrical fault leakage or electric appliances and socket drag line is capable of tripping protection. If even the lamps and lanterns also will be black when accessing, the lamps and lanterns are unable to touch in most situations, even if the lamps and lanterns leakage electricity arrives the human, also can not be fatal. [on leakage protective circuit breaker] Leakage protection circuit breaker can be connected to any one line (220V), and if there is a difference, what is the difference? What is the specific application? There are two kinds of low voltage leakage protective circuit breakers: single-phase and three-phase. Say first phase, it is generally used for civilian use. There is a line of fire and a zero line terminal, and the zero line is marked by N. The fire line is marked with L. When the leakage occurs, the current of two wires will be unbalanced. At this point, the leakage protection breaker will trip. Say three phase first, generally used for industrial production. There are four lines, as we often say, three-phase four lines, of which there are three FireWire and a zero