教你如何验槽（Show you how to test the slot）.docVIP

教你如何验槽（Show you how to test the slot） Trough inspection, especially the technical expertise of geotechnical professionals, whether the groove is careful or not, is the key to the safety of the whole building. Every engineering and technical personnel, each of the foundation ditch, we should be cautious, there must not be any negligence, can not let any traces. During construction, structures must be constructed for inspection of buildings requiring grade two and over two. Inspection should be done according to the following methods and procedures: 1 inspection tank must have the data and conditions: 1.1 the personnel and technicians involved in the survey, design, quality supervision, supervision, construction and construction are present; 1.2 with the basic plane and structure of the general description of the construction drawings phase of the structure; 1.3 detailed survey of geotechnical engineering investigation report; 1.4 after excavation, the bottom of the tank without air, soil (if section excavation, each section under the same conditions of good foundation). 2 can not check the groove: One of the following conditions can not meet the basic requirements of the test tank; it is impossible to test the tank: The 2.1 trench bottom surface and the design elevation is too large; The 2.2 trench bottom slope, elevation difference between; 2.3 the bottom of the tank has obvious mechanical rutting marks, and the disturbance of the trough subsoil is obvious 2.4, the bottom of the tank has obvious mechanical excavation, no artificial cleaning groove, shovel teeth traces. 2.5 there is no detailed geotechnical investigation report or detailed drawings of the structural design general drawings at the site. 3 preparation before test tank: 3.1 look at the structural description and geological survey report, compare the foundation bearing capacity of the structure design and whether the supporting layer is the same as that provided by the report; 3.2 ask and see whether the