硬盘编译码的fpga实现(FPGA implementation of hard disk encoding and decoding).docVIP

  • 2
  • 0
  • 约1.75万字
  • 约 14页
  • 2017-10-07 发布于河南
  • 举报

硬盘编译码的fpga实现(FPGA implementation of hard disk encoding and decoding).doc

硬盘编译码的fpga实现(FPGA implementation of hard disk encoding and decoding)

硬盘编译码的fpga实现(FPGA implementation of hard disk encoding and decoding) FPGA implementation of hard disk encoding and decoding Journals reviewed Preface In a storage system, channel encoding includes two steps, error correcting codes and code modulation, the modulation code converts input data bit sequence in addition, properties of the sequence satisfies the recording equipment specific physical nature of characteristics, namely channel constraints. During peak detection, when the two jumps in the channel sequence are very close, the corresponding two pulse signals will produce crosstalk, which will lead to the peak deviation of the pulse signal. This phenomenon is called interference Inter Symbol (ISI). Many storage systems use run length limited codes to overcome intersymbol interference, which is represented by RLL (D, K). The length of time between two adjacent jumps represented by a channel is called run length. D and K these two parameters specify the minimum and maximum run lengths that may occur in the sequence, i.e., the modulation code two, at least 0 0 between 1 and K at most, d. The parameter d controls the highest transfer rate to avoid intersymbol interference when the sequence is transmitted through the band limited channel, and the parameter K ensures the proper jump frequency to meet the need of the PLL to read the clock synchronization. RLL modulation codes are most widely used in optical and magnetic storage. Run length restricted codes with different D and K parameters: D K Rate R Name application Two Ten 8/17 EFM CD Two Ten 8/16 EFM+ DVD One Seven 2/3 (1,7) PP Blu-ray Two Seven 1/2 (2,7) Magnetic tape One Three 1/2 MFM floppy disk For the design of RLL encoding, Franaszek proposes a special variable length code, that is, synchronous variable length codes. Although the source word and codeword length are variable, the ratio of the source word and its corresponding codeword length is fixed. At present, this kind of coding is widely used in all kinds

您可能关注的文档

文档评论(0)

1亿VIP精品文档

相关文档