导入武器（Import weapons）.docVIP

导入武器（Import weapons） Hello, this time, I will trigger the newbie to explain the model import problem. This tutorial I was named: Much like the old womans broken mouth bindings in the history of the most detailed tutorial in the super invincible! (-_-!) Model introduction can be divided into unit model, weapon model, effect skill model, import and so on. A unit model is a unit of Warcraft, such as the figure below, which is a new Orc unit. A new Tauren Warrior Ill explain the process of importing the model in detail. Lets begin with the introduction of the Tauren warrior model. First, open the Tauren ZIP file. You should see a folder called Tauren champion. As shown. Open this folder to whatever you like and open it later. Youll find a total of five files. Two of the text files (README files) we do not need, so do not go to it, the text file is usually used to remind you of some information. What we need is three additional files. They are called Taurenarcher.blp, taurenchampion.blp, taurenchampin.mdx. Among them, the BLP file is the skin file, and the MDX file is the model file. The model you need to import should normally only use the two file types. (weapon model files sometimes have only MDX files instead of BLP files) As shown. OK, now open your Warcraft map editor, thats World Editor. When you open, click Import Manager (or press F12) As shown. The red mark on the left side of the green arrow icon is the import manager. (you can press the shortcut as well, press F12.) Now youll see the window of the import manager. Following chart. See the green arrow icon on the left? Click it, and it will let you import the file. Locate the folder where you placed the Tauren champion folder, open the folder, and enter three files that we need. (2 BLP files and 1 MDX files) Now your import manager should be like this. Following chart. Attention, the following is very important. Is there a whole path behind the picture? Path below, respectively: War3mapimported\taurenarcher.blp