汽车防盗器安装（Installation of car burglar alarm）.docVIP

汽车防盗器安装（Installation of car burglar alarm） The third chapter is the trigger and judgment method of various control lines Contents of this chapter 1-3-1 locking trigger mode and connection judgment 1-3-2 direction light control line judgment 1-3-3 door switch, contact sensing, door cover, trunk connection judgment 1-3-4 power up window, foot brake, ACC, remote start control line judgment Inspection method of 1-4-4 oil pump line A lock, trigger mode and connection judgment 1, the negative trigger judgment: the test pen clip is connected with the ground (ground). Two control lines end touch stylus test lock, if the lock, the two line is a negative trigger control line lock. 2, it triggered judgment: test pen clip connected, two control lines end touch stylus lock, if the lock, the two line is the line trigger control lock. 3, positive and negative trigger judgment: if using the above two methods are used to judge the lock, the positive and negative trigger mode. 4, single series negative trigger judgment: with only one test pencil line lock, then find no lock line, and cut the line will unlock. 5, positive and negative trigger and positive loop judgment is the same, some people say. A positive or negative trigger does not necessarily have a positive loop. They judge the method is to unlock or lock the lock, there are two with positive line, disconnect, these two can be positive and negative trigger, but not necessarily with positive loop. In the break line, and then to lock in respectively a positive charge and then look at the lock is opened or closed, it sure is not positive loop. 6, double potential trigger: he is in the same line will have two action at a time of high voltage and low voltage (shidianbi clip negative, a test in the control box, if a line appears on or off, meet again, open or closed, there are two potential negative touch) 7, single line negative trigger (judge method is the same line repeated action, give a power to move once) 8, single line series