简析机械毕业设计英文外文翻译602自动机械卫星(RS)双机械.docVIP

　　简析机械毕业设计英文外文翻译602自动机械卫星(RS)双机械 简析机械毕业设计英文外文翻译602自动机械卫星(RS)双机械 导读：机械毕业设计英文外文翻译602自动机械卫星(RS)双机械手协调运动的规划设计 Safety and Maintenance For C Machine 1 Safety Notes for C machine Operations Safety is alajor concern in a metal-cutting Operation. C equipment is automated and very fast, and consequently it is a source of hazards , The hazards have to located and the personnel must be a in order to prevent injuries and damage to the equipment. Main potential hazards include, rotating parts, such as the spindle, the tool in the spindle, chuck, part in the chuck, and the turret ping devices, movable parts, such as the machining center table, lathe slides, tailstock center , and tool carousel, errors in the program such as improper use of the G00 code in conjunction otion, an error in setting or changing the offset value ,achine, and a hazardous action of the machine caused by unqualified changes in a proven program, To minimize or avoid hazards, try the folloachine as supplied by the machine tool builder (2) (3) Wear 3 4 5 6 7 8 9 10 简析机械毕业设计英文外文翻译602自动机械卫星(RS)双机械 导读：机械毕业设计英文外文翻译602自动机械卫星(RS)双机械手协调运动的规划设计 safety glasses, gloves, and proper clothing and shoes. Do not attempt to run the machine before you are familiar , make sure that the parts is clamped properly. (5) , follo using the machine Lock function to check the program for errors in syntax and geometry. ? Slootions using the RAPID OVERRIDE s. ? Use a single-block execution to confirm each line in the program before executing it. ? achine if you need to properly clean the chips. (7) If there is any doubt that the insert med cutting conditions, choose a thicker insert or reduce feed or depth of cut. (8) Keep tool overhang as short as possible, since it can be a source of vibration that can break the insert. (9) ake sure that the 3 4 5 6 7 8 9 10 简析机械毕业设计英文外文翻译602自动机械卫星(RS)双机械 导读：机械毕业设计英文外文翻译602自动机械卫星(RS)双机械手协调运动的规划设计 hole-center is large enough to adequay support and hold the part. (10) Stop the machin