对接糊口操作规程.docVIP

玻璃钢管道直管平端对接糊口操作规程Glass Pipe straight flat end of butt ends meet operational procedures 一、平端对接糊口操作步骤1, flat-side docking steps make ends meet （1）材料来源 所用材料由安装单位按生产厂根据工况和介质条件等提供的材料清单自行采购，也可由生产厂家提供。(1) sources of material  The materials used by the installation of units and plants under the conditions of working conditions and media to provide a list of materials on their own procurement, may also be provided by the manufacturer. （2）原材料准备 按工艺单上的种类和数量，准备好原材料。布和短切毡应根据产品的规格尺寸，提前裁剪好。有锁边的布应将锁边剪掉，短切毡的边口用手撕毛。以上原材料须是检测合格的方可使用。如有需要更换的材料或变动铺层，需经有关工艺员书面认可，方可变动。(2) Raw material preparation  According to process a single on the type and quantity of raw materials ready. Cloth and chopped strand mat product specifications should be based on size, ahead of a good cut. A lock the lock side edge of cloth should be cut, chopped strand mat edges of mouth Shousi hair. The above raw material shall be tested and may use. If necessary, replacement materials or changes in shop floor, subject to written approval of the craft before they change. （3）切割打磨 根据图纸，找出需对接的管道，并检查规格、长度、压力等级与设计要求是否相符。在需切割处用记号笔划好切割线，用装有金刚石砂轮片的角向磨光机将需胶接的部位切开，切口应平整，切割尺寸误差不大于2mm。 (3) cutting polishing According to drawings, to identifying docking pipeline, and check size, length, pressure rating is consistent with the design requirements. In the need to draw a good cut at cutting line with the marker, using films with diamond wheel angle grinder will need to cut bonding site of the incision should be flat, cut size of the error is not greater than 2mm. 根据对接宽度将需胶接的地方用装有软片砂轮的角向磨光机进行打磨，切口处打磨坡度大于45°，并且应磨到内衬层（内衬层厚度1.5-2.5mm）。 According to docking width will be glued in place with the film wheel with angle grinder for grinding, polishing incision slope greater than 45 °, and should wear to the inner layer (lining layer thickness 1.5-2.5mm). （4）对接定位 按下图将找正环(或膨胀环)塞入一头对接口，涨紧后，把另一接头套在找正环上，然后将两对接头推紧合缝，对正找平，使中间的离缝尽可能地小，并用水平仪检查管线是否水平，轴心线是否在同一直线上，方向是否正确，法兰眼是否对正(如果有法兰的话)。如果口径较小(DN400以下)或无找正环，亦可直接对正。(4) docking orientation