基于热辐射成像建模求解的管式炉炉管温度检测-openrepositoryof.pdfVIP

66 3 Vol.66 No.3 2015 3 CIESC Journal March 2015 1 2 2 1 1 710032 2 100084 Monte Carlo DRESOR 2% DOI 10.11949/j.issn.0438-1157 TK 224 A 04381157201503096507 Visualization of pipe temperature distribution in tubular furnace based on radiation imaging model solving 1 2 2 1 ZHANG Xiangyu , ZHENG Shu , ZHOU Huaichun , XU Hongjie 1 ( National Engineering Research Center of Clean Coal Combustion, Xi ’an Thermal Power Research Institute Co., Ltd., Xi ’an 710032, Shaanxi, China; 2Institute of Simulation Control of Power System, Tsinghua University, Beijing 100084, China) Abstract Accurate measurement of temperature distribution of pipe surface becomes the key issue for optimization of heating process in tubular furnace. Experiment research of visualization of pipe temperature distribution was conducted on an industrial ethylene cracking furnace based on radiation image processing. Inside the furnace pipe, thermal cracking reaction of naphtha occurs, whose reaction heat is provided by eight burners located on the bottom, and the fuel is natural gas. Coking of furnace pipe was ignored in the model. In order to deal with the radiative heat transfer equation with complex boundary condition in the tubular furnace, a DRESOR method based on Monte Carlo principle was used, and the radiations from tubes, flame and furnace wall were d