外文翻译原文-利用稳态测量跟踪电力系统等效电路参数.pdfVIP

Tracking Power System Equivalent Circuit Parameters Using Steady State Measurements S. A. Arefifar, Student Member, IEEE, and W. Xu, Fellow, IEEE estimated [3]. Abstract -- This paper deals with the problem of calculating the Several methods have been proposed so far to track and power system equivalent circuit parameters using local estimate the power system impedance, which have their own measurements at the point of common coupling (PCC). For this advantages and disadvantages. Some of them are based on purpose, a new algorithm based on three sets of measurements is synchronized measurements of waveforms and some require proposed. The proposed algorithm is more practical and has some advantages over the previous methods. The necessary nonlinear load to estimate power system equivalent circuit. measured data for this approach are magnitude of voltage and These methods basically refer to two different approaches. current and the power factor. Verification studies, including The non-invasive approach uses the existing load current and simulation and experimental results, are provided to verify the voltage variations to identify the network equivalent algorithm. Moreover, some practical situations such as noise impedance [2-6], and the invasive approach, uses the condition and slow variations of system parameters are switching transients caused by network equipment