基于flexsim仿真平台下的税收业务流程仿真与优化.doc

基于Flexsim仿真平台下的税收业务流程仿真与优化 摘要 2011年，经下发营业税改增值税。，税收制度。的增值税条例，Tax business process simulation and improvement based on the simulation platform of Flexsim Abstract In 2011, approved by the relevant departments, commonly make a decision about the business tax turning into the value-added tax, covering with transportation industry and part of the third industry. Consequently, a new round of tax system reform start. This paper mainly make a research on the reform, specific work is as follows: Firstly, putting forward the paper background, analysising and researching the meaning of the thesis.Setting forth about international document , constructing the architecture diagram in this paper. Secondly, Analysis of VAT, build a flow chart, make a comparison. Then Introduce Flexsim and help for this article After then, Combination withs pecific cases, simulation process of tax. In the end, the paper will do a calculation base on above work, Using the data shows that the VAT have an impact on development of logistics industry. However, the temporary value-added tax rules variety from small scale logistics enterprises and no corresponding accounting cost, it is not included by VAT. So the paper is mainly aimed at some logistics enterprise except for small-sized,then tax process improvement and puts forward proposal of optimizing our nations logistics business tax paid VAT policy instead, as a result of achieving the effect of lower corporate taxes. Key words：taxes processesBT to VAT reforms；Flexsim； simulation and modeling；logistics摘要 I Abstract II 第一章 导论 1 1.1研究背景及意义 1 1.2国内研究情况 1 1.3 本设计主要的架构 4 第二章 税收业务流程分析 6 2.1税收的基本定义 6 2.2 “营改增”改革前后流程图的构建 6 2.3营改增前后对比 9 2.4根据税收流程初步建立适合仿真的流程图 11 第三章 基于Flexsim仿真软件的概述 13 3.1 Flexsim基本简介 13 3.1 .1 Flexsim软件定义 13 3.1.2Flexsim模块组成 13 3.1.3 Flexsim的特点 14 3.1.4 Flexsim软件使用方法 15 3.2 Flexsim与其他软件差异及选择理由 16 3.2.1 与Flexsim的对比 16 3.2.2 选择Flexsim原因 19 第四章 税收仿真设计优化及相关建议 20 4.1利丰物流公司概述 20 4.1.1 利丰物流公司简介 20 4.1.2 耐克物流工作基本流程 20 4.1.3 公司物流仿真 24 4.2