厂房地脚螺栓.docxVIP

The embedding of anchor bolts on the steelstructure factory building地脚螺栓的埋置是钢结构厂房施工的一大关键，直接影响到上部钢结构厂房的垂直度，方正度。若地脚螺栓的埋置偏差过大，则会对后期的上部施工中的结构螺栓，檩条螺栓，围梁螺栓的连接等造成很大的困难。在施工过程中，我们要着重控制地脚螺栓的平面位置，垂直度及螺栓钉标高，以尽可能减少上述误差。For direct influence on the perpendicularityand square, the embedding of anchor bolts is one of the most important pointsduring the construction of steel structure building. There would be greatdifficulties in working on structural bolts, purline bolts, and girt bolts ifthere is any declination in embedding the anchor bolts. During construction,the great emphasis should be placed on the horizontal position,prependicularity and elevation of bolts in order to reduce such declination tothe least..要求：平面位置误差：＋3mm，螺栓顶标高误差：＋3mmBasicrequirements:Horizontal position declination: 3mmAnchor bolts top elevation declination: 3mm§1 须配备的设备，工具及施工人员：Workingstaff, Necessary equipment and Tools:1.1 设备及工具：Equipment and tools:光学水准仪及脚架，标尺1套Optical water level horse and staff guage1 光学经纬仪及脚架，花插1套Optical theodolite,horse flower brace1 50m以上钢尺1把Steel rule(over 50m)13m－5m钢尺2把Steel rule(3-5m)2线锤1只Thread hammer1模线若干Module stringsome铁锤1把Hammer1定位界椿若干Orientationmarkersome电焊机1台Electric welding machine1水平靠尺（高精度）1把Leveling guiding rule(Highprecision)11.2 施工人员：Working staff有经验的测量工程师1人Well-experiencedmeterage engineer1钢筋工1人Reinforcing steel barworker1电焊工1人Electric welder1木工1人Carpenter1辅助工2人Assistant2 §2·板样定位及水准点：? ?? ?Model orientation and Standard Leveling Point2.1 板样定位：? ? Model Orientation:根据图纸要求，对施工现场进行放样，定位。在所有建筑物的角点，必须设立横向，纵向两个控制界柱，并采取适当的加固措施，避免控制界椿在施工过程中遭破坏，所有横向，纵向轴线均设立相对固定的定位椿。所有定位椿的顶标高尽量控制在＋0·000上10－20cm，以便日后拉模线，拉尺丈量复核。定位界椿设立之后，应采取反方向闭合测量，修正成果，以减少平面误差To locate the position and lofting on the job site according to the drawing. Both transverse and lengthways controlling boundary column should be embedded at the corner of every building, the corresponding consolidating measures also should be taken so as to prevent the controlling boundary column from damaging during the erection. The top el