Microstructure and Mechanical Properties of Sub–rapidly Solidified Fe–Mn Based Alloy Strip论文.pdfVIP

Microstructure and Mechanical Properties of Sub–rapidly Solidified Fe–Mn Based Alloy Strip ·1 · Microstructure and Mechanical Properties of Sub–rapidly Solidified Fe–Mn Based Alloy Strip 1 1 1 Yang Yang , Song Changjiang , Duan Lian , Zhang Yunhu 2, Zhai Qijie 1 (1. State Key Laboratory of Advanced Special Steels, Shanghai University, Shanghai, China; 2. Helmholtz-Zentrum Dresden-Rossendorf, 01314 Dresden, Germany) Abstract The purpose of this paper was to investigate the microstructure and the mechanical properties of Fe-Mn binary alloys and Fe-Mn-C ternary alloys prepared by using sub-rapid solidification technique. The results demonstrated that the ε-martensite and α’-martensite would be directly formed in the sub-rapidly solidified Fe-Mn and Fe-Mn-C samples. And the lath width of ε-martensite and α’-martensite was lower than that of sample produced by conventional method. The mechanical properties of Fe–Mn and Fe-Mn-C samples prepared by sub–rapidly solidification were even higher than those by hot rolled and heat treated. This work discusses the relationship between the microstructure and the mechanical properties of the strips. Key words sub-rapid solidification, TWIP steel, mechanical property, microstructure 1 1 Introduction High-Mn steels exhibit both high tensile strength and good ductility and have attracted much attention as a promising candidate for next-generation automotive steel. However, there are still problems in conventional prod