弧面凸轮专用加工机床中心距误差对凸轮廓面误差-北京工业大学学报.pdfVIP

第40卷 第6期 北 京 工 业 大 学 学 报 Vol.40 No.6 2014年 6月 JOURNAL OF BEIJING UNIVERSITY OFTECHNOLOGY Jun. 2014 弧面凸轮专用加工机床中心距误差对 凸轮廓面误差的影响 纪姝婷,张跃明,赵摇 京 (北京工业大学 机械工程与应用电子技术学院,北京摇 100124) 摘摇 要:研究了弧面凸轮加工机床的中心距误差. 利用等距曲面理论建立了弧面凸轮廓面方程,以及弧面凸轮廓 面加工误差的数学模型,给出了中心距误差影响系数的计算方法. 通过一个凸轮机构实例,求解不同走刀轨迹对应 的中心距误差影响因子曲线,得到了加工廓面误差的变化规律;用VC+ +编程和PROE软件仿真出了加工廓面及 加工廓面误差,揭示了由于加工机床中心距误差的存在导致弧面凸轮廓面加工误差,以及引起弧面凸轮机构的冲 击、碰撞的产生机理. 研究结果表明:加工机床中心距误差影响凸轮机构的啮合性能,对弧面凸轮的动力学性能有 重要影响. 关键词:机床中心距误差;弧面凸轮;廓面误差 中图分类号:TH161 文献标志码:A 文章编号:0254-0037(2014)06-0825-06 Influence of the Center Distance Error of Machine Tool on the Profile Error in Machining Globoidal Cam JI Shu鄄ting,ZHANG Yue鄄ming,ZHAOJing (College of Mechanical Engineering and Applied ElectronicsTechnology,Beijing University of Technology,Beijing 100124,China) Abstract:The effect of center distance error of machine tool employed in machining globoidal cam was discussed. Based on the offset surface theory, the equation of the globoidal cam profile and the mathematical model of theprofile errorwere established,andthe sensitivity coefficient of the center error was derived. The variation of the sensitivity coefficient corresponded to different tool paths was further investigated. The real profile and profile error were simulated through VC+ + and PROE software,and the impact and collision of the globoidal cam mechanism caused by the center distance error and its generation mechanismwererevealed. Resultsshow thatthecentererrordegradesmeshingquality andhas a bad influence on the transmission performances. Key words:center distance error of machine tool;globoidal cam;profile error 摇 摇 弧面凸轮机构以其结构紧凑、分度精度高、承载