轮机英语题库1601-1800.pptVIP

轮机英语考试强化复习（3000KW及以上船舶二管轮/三管轮） 轮机工程学院辅机教研室 1745 Refrigerant enters the condenser as a___. A. high pressure liquid B. low pressure vapor C. high pressure vapor D. low pressure liquid 1746 If the pump for a hydraulic anchor windlass is overheating, the cause may be_____. A. excessive drive motor speed B. excessive pump discharge pressure C. too low of a tilting box angle D. insufficient drive motor speed 1747 An independent bilge suction is required for_____. A. ballast tanks B. sludge tanks C. machinery space bilges D. cargo hold bilges 1748 In a flash distilling unit, evaporator feed (seawater) first absorbs heat in the_____. A. vapor feed heater B. air ejector condenser C. saltwater heater D. distillate cooler 1749 The function of lubricating oil is to_____. A. reduce friction between moving surfaces B. provide even distribution of bearing wear C. reduce the accumulation of harmful detergents D. maintain a constant oil temperature output at each beating 1750 A dirty intercooler on the ship service air compressor will result in_____. A. decreased compression ratio B. higher than normal power consumption C. un-loader malfunction D. water in the lubricating oil 1751 Which of the listed conditions will cause the feed water, that has not flashed to vapor in the first-stage of a flash evaporator, to flow into the second-stage? A. Gravity siphon 虹吸effect. B. Higher vacuum in the second-stage. C. Difference in brine density between first and second stages. D. lower pressure in first-stage. 1752 Under normal operating conditions, the highest temperature and pressure conditions existing in a flash-type evaporator will occur in the_____. A. first stage B. second stage C. distillate cooler D. salt water feed heater 1753 A dirty intercooler on an air compressor will cause_____. A. damage to the un-loader operating di