ASME焊材管理程序.doc

Zhenjiang JinMen Industrial Co., Ltd ASME Procedures JM/ASME-04 Welding Material Control Procedure Rev. No.: 0.0 Page：1 of 5 Welding Material Control Procedure 焊 接 材 料 管 理 程 序 Prepared by Date _____________ 编 制： 日期： Approved by _________________ Date ____________ 批 准： 日期： Accepted by _________________ Date ____________ 认 可： 日期：  Zhenjiang JinMen Industrial Co., Ltd ASME Procedures JM/ASME-04 Welding Material Control Procedure Rev. No.: 0.0 Page：2 of 5 1 Scope 范围 1.1 This procedure provides supplementary requirements to the QC Manual and “General Material Control Procedure” （JM/ASME-02）about the storage, baking, issuance and return of welding consumables used for construction of ASME Code items. 本程序规定了质量管理手册和材料控制程序的关于用于制造ASME规范产品的材料的存储、烘干、发放和返还焊材的补充要求JM/ASME-02。 2 Receiving Inspection of Welding Consumables 焊材的接收检验 2.1 QC Engineer shall provide sufficient training and knowledge to the Material Keeper about the welding consumables control requirement in the QC Manual. The Material Keeper shall be familiar with the general requirements and specifications of welding materials. 质量控制工程师应为材料保管员提供在质量管理手册上关于焊材控制要求的足够的训练和知识。材料保管员应熟悉总则的要求和焊材规范。 2.2 When receiving welding consumables, the Material Keeper shall check and verify welding consumable as per “Material Requisition”. He shall check the marking of the welding consumable container in accordance with the applicable specifications. He shall also inspect the condition of packing in order to assure that no damage has been occurred. 当接收焊材时，材料保管员应根据材料申请单检查和检验焊材。他应根据适用的规范检查装焊材的容器。为了确保没有损坏发生，他应检查包装的情况。材料保管员只能对焊材的外观、数量、批号、牌号进行检验，对焊材内部质量的检验应由材料检验员进行检验，而不应由保管员进行检验。 3 Storage of Welding Consumables 焊材的储存 3.1 Welding materials shall be stored in such the way as specified in the General Material Control Procedure. 焊材应按照材料管理程序的要求被储存。 3.2