汽车轮帽外壳模具设计（有cad图）.pdf

摘 要 本设计论文系统阐述了汽车轮帽塑料注射模设计过程，根据 汽车轮帽塑件的形状和生产要求，编制汽车轮帽塑件的设计过程， 初步制定了总体模具的设计方案。论文首先对汽车轮帽塑件进行 了详细的工艺性分析，然后进行注射模结构设计，比如分型面的 选择，抽芯机构的设计等，并进行模具设计的相关的计算,完成型 腔和型芯工作尺寸的计算等，接着对整个模具的进行相关校核， 最后完成整个汽车轮帽注射模设计，并绘制出模具的总装图和非 标准件的零件图。 本设计方案结构紧凑，满足制品大批量生产、高精度、外形 复杂的要求，设计参考了以往注射模具的设计经验，并结合制件 性能，简化设计机构，并且运用AutoCAD 等软件进行绘图，缩短 了生产周期，并且获得良好的经济性能。 关键词：汽车轮帽；注射模设计；硬聚氯乙烯；侧向抽芯 1 Abstract The thesis systemic introduce the design process of the plastics injection mould of four-way pipe, base on the shape and the productionrequirementoffour-waypipe,atthesametimethearticle establishthedesignprocessoffour-waypipeproduce,andelementary setdownthedesignschemeofthetotalinjectionmold.Thefour-way pipeproduceadoptsinglecavityofinjectionmoulddesign，usethe mechanism of liquid pressure lateral loose core and incline leader lateral loose core,and the mechanism of handspike. First, the thesis analysethecraftofthefour-way pipeproduceparticular, thenfinish the structure design of four-way pipe injection mold, such as the choiceofthepartingsurface,thedesignoflateralloosecorestructure etc..Second,thepaperfinishthecalculationerelatedwiththeinjection mold design, for example the calculation for the work size of the cavityandcore.Third,thearticlecompletetheparametricrelatewith thewholeinjectionmoldingchecking.Finally,thethesiscompletethe designofthewholefour-waypipeinjectionmold,anddrawthetotal assembly chart and the accessory chart of the non-standard of the mold. This design is compactness for fulfilling volume-produce, demandwithcomplicatedhighaccuracyandappearance,atthesame timereferencesancientlyexperienceofinjectionmouldandcombines characteristic of produce to project organization simplify the project organization.Inordertoshortenproductioncycleandobtainfavorable efficiency, the two-dimension and triaxiality draw